HitLights LED PCB RGB LED Strip Any Angel Turn Connector, 4 Conductor, For SMD5050 or SMD 3528 RGB Color Changing LED Strip, Strip to Strip, 4 pcs

Very handy for splicing our 2-conductor RGB Color changing LED strip lighting together, strip-to-strip. Typically, this is used for making a right turn with our LED strips: cut the strip on the cut line, splice the ribbon electrically with this jumper and bend the wires 90 degrees (or whatever angle you require,) and keep going with the LED strip. Gently pull the black slider unit away from the white. It will slide out only about a millimeter. Gently slide the ribbon into the connector and then slide the black slider into the white connector body and you'll feel the connector grab the ribbon. It won't make an audible click, but it will feel like it clicks into place. Note that if the backing protecting the adhesive on the back of the ribbon has been removed, the ribbon will be a little thinner than usual, and the connector may not hold the ribbon. If that is the case, or if the connector won't grab the ribbon for any reason, just put a small piece of masking or other tape on the back of the ribbon to make it thicker so the connector can hold it. Do not put the tape on the top of the ribbon or the connector won't connect electrically.