Attach a spotlight anywhere: to your house, shed, garage, or even a tree. This 3-pack of Mr. Beams MB330 spotlights offers simple installation with no wiring and no electrician needed.

Tight seals and weather-resistant materials allow a Mr. Beams Spotlight to work in all weather conditions.
Mr. Beams spotlight turns off automatically after 30 seconds of no motion, conserving battery life.
The spotlight instantly turns on when it detects motion, and can detect motion from as far as 30 feet away with 180 degrees of vision.
The bright LED and housing design focus 140 lumens of light where you need it--perfect for wall mounted lighting applications.
The bright LED never needs replacing--it's so efficient that you will get more than 1,800 activations on one set of batteries.
The MB333 from Mr. Beams is a battery-powered, wireless, motion-sensor LED spotlight that requires no wiring. Simply insert batteries and attach to any surface. The thin profile of the MB333 means you can mount it in a convenient location and it won't get in your way. A built-in photocell activates the motion sensor only after the sun has set or when the lights are out. The MB333 is weatherproof for year-round illumination. Attach these spotlights anywhere in minutes without an electrician. The white color option makes the MB333 a great option for indoor and outdoor applications where the color is important.
Mr. Beams LED lights provide indoor and outdoor lighting solutions where you need them most. Intelligent motion-sensors activate battery-operated LED lights for hands-free lighting. All units are IP44 rated, which means the weatherproof design will satisfy both indoor and outdoor LED light applications. All Mr. Beams LED lights install easily--no wiring, no electricians--so you can be assured of quality LED lighting anywhere.
The MB333 motion sensor LED spotlight (white) has a photocell inside that activates the LED when it is somewhat dark to conserve battery life. This is often referred to as a "dusk-to-dawn" sensor because if it is used outdoors, it will start to work early in the evening through to the morning when it starts to get light out. It does not have to be complete darkness as the light sensor will enable the light if the detected light level is low (with a light intensity below about 3.5 lux at the light).
To test the MB333 before installation or at any time, it's recommended to put fresh batteries in and take it into a dark room. Leave the room to avoid your motion retriggering it. The light should shut off after a minute or two (the motion sensor may need time to settle immediately after putting the batteries in). When you walk into the room, the motion sensor should trigger turning the light on.
3 x Mr. Beams MB330 motion sensor LED spotlights, 9 screws, 6 mounting anchors, and user manual.