Attach a ceiling light anywhere: in your closet, stairway, attic, basement, utility room, porch, gazebo, garage or shower. Mr. Beams offers simple installation with no wiring and no electrician needed.
Tight seals and weather-resistant materials allow a Mr. Beams ceiling light to work in all weather conditions.
Mr. Beams stick anywhere ceiling lights turn off automatically after 30 seconds of no motion, conserving battery life.
The ceiling light instantly turns on when it detects motion, and can detect motion from as far as 20 feet away with a of field of motion detection optimized for ceiling mount application.
The bright power LED provides 100 Lumens of bright white light. A custom optical design is used to intensify the light by focusing it where it is needed.
The bright LED never needs replacing--it's so efficient that you will get more than 3,200 activations on one set of batteries.
The MB980 from Mr. Beams is a battery-powered, wireless, motion-sensor LED ceiling light that requires no wiring. Simply insert batteries and attach to any surface. A built-in photocell acts as a dusk to dawn sensor activating the motion sensor only after the sun has set or in a fairly dark room. These are fantastic bright indoor and outdoor lights for closets, stairways, attics, basements, utility rooms, porches, sheds, garages or showers. The MB980 is weatherproof for year-round illumination. Attach these ceiling lights anywhere in minutes without an electrician.
Mr. Beams LED lights provide indoor and outdoor lighting solutions where you need them most. Intelligent motion-sensors activate battery-operated LED lights for hands-free lighting. All units are IP44 rated, which means the weatherproof design will satisfy both indoor and outdoor LED light applications. All Mr. Beams LED lights install easily--no wiring, no electricians--so you can be assured of quality LED lighting anywhere.
The MB980 motion sensor LED ceiling light has a photocell inside that activates the LED when it is somewhat dark to conserve battery life. This is often referred to as a "dusk-to-dawn" sensor because if it is used outdoors, it will start to work early in the evening through to the morning when it starts to get light out. When installed indoors the MB980 should be installed in a space that is fairly dark. It does not have to be complete darkness as the light sensor will enable the light if the detected light level is low (with a light intensity below about 3.5 lux at the light).
To test the MB980 before installation or at any time, it's recommended to put fresh batteries in and take it into a dark room. Leave the room to avoid your motion retriggering it. The light should shut off after a minute or two if the light is working properly (the motion sensor may need time to settle immediately after putting the batteries in). When you walk into the room, the motion sensor should trigger turning the light on.
Mr. Beams MB980 motion sensor LED ceiling light, mounting plate, 2 screws, 2 mounting anchors, user manual. Runs on 4 C batteries (not included).